Kohler K-1840 Guia De Instalacion página 7

Verify Fit
1/4"
(6 mm)
Verify 1/4"
(6 mm)
overlap.
4. Complete the Site
Verify Fit
Temporarily insert the unit into the stud pocket.
Vertically center the unit, then verify the attachment flanges overlap the wall material a minimum of
1/4" (6 mm).
IMPORTANT! If a minimum of 1/4" (6 mm) overlap does not exist: Set the unit aside, remove the wall
material, then repeat the option selected in the "Prepare the Site" section. If a minimum of 1/4" overlap
exists: Set the unit aside, then proceed with the installation.
Tile the Shower Area
IMPORTANT! When planning the tile layout, the tile must be flush with the edge of the wall material
at the cutout location for the unit.
Plan the tile installation for the walls, then mark the plan on the wall material.
Attach the tile with tile adhesive or thin-set mortar designed for wet environments.
Allow the tile adhesive or thin-set mortar to cure.
Apply grout to the tile, except for the expansion joints in the alcove.
Wipe the area with a damp sponge, allow the grout to set, then buff the tile with a soft cloth.
Kohler Co.
1/4"
(6 mm)
Tile the Shower Area
Verify tile
is flush
with edge.
7 1071003-2-B