Product Specifications; Care And Maintenance - Homewerks 3220-140-CH-BC-Z Instrucciones De Ensamblaje

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 1.2 GPM (4,542 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Chrome finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Place new faucet in position on
sink. From under sink, thread
mounting nuts onto faucet.
Tighten mounting nuts. Do not
over tighten.
You may use plumbers putty or
a water proof silicone to seal
the deck plate to the sink.
INSTRUCTIONS FOR USE
Each handle controls the flow of either hot or cold water to the spout. To create a moderate water temperature turn both the handles open. Slight adjustments of
either handle will cause the water temperature to increase or decrease.

CARE AND MAINTENANCE

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
www.homewerksww.com
1
2
SPECIFICATIONS
Washerless cartridges
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
Total weight of item: 1.815 lbs.
3. Connect water supply lines.
(1) Use 1/2" IPS faucet supply
lines or (2) use coupling nuts
(included) with (3) ball-nose
risers (not included).
Turn water supply or shut-off
valve back on and check for
leaks. If leaks occur, gently
tighten the faucet connections.
4. Important: After installation is
completed, remove aerator.
Turn on water supply and allow
both hot and cold water to run
for at least one minute each.
While water is running, check
for leaks. Replace aerator.
Tighten nuts slightly to stop
minor leaks. If problems persist,
refer to troubleshooting chart.
2
3
3
1
2
4