GB
Gas pot
Gas pot
Fig. 5.15
Fig. 5.14
3. Discharge Oil
a) Press the start switch to the STOP position and make sure the fuel cap is fully closed.
b) Loosen the cover screws and remove the maintenance cover.
c) Place a container next to the engine to catch the used oil.
d) Remove the oil filler cap/dipstick and drain the oil into the container by tilting the generator.
e) Remove the screw, top maintenance cover and the spark plug.
f) Fill the spark plug orifice with 2 cc's (about a tablespoon) of fresh oil. Pull the start motor 34 times to
distribute the oil.
g) Reinstall the spark plug, top maintenance cover and screw securely.
h) Pull the starter grip slowly until you feel resistance, then return the starter grip gently. This closes the
valves so moisture cannot enter.
71