Description (Fig. A) - Ferm ESM1010 Traducción Del Manual Original

TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No-load speed
Protection class
Weight
NOISE AND VIBRATION
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration
Uncertainty (K)
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns

DESCRIPTION (FIG. A)

Your orbital sander has been designed for sanding
wood, metal, plastics and painted surfaces.
1. On/off switch
2. Dustbag
3. Speed adjustment wheel
4. Sanding pad
5. Main grip
6. Lock-on button
7. Dustbag connection
6
ASSEMBLY
V~ 230
4
Hz 50
W 430
min 5,000 - 13,000
-1
Mounting and removing the sanding paper
IP 20
(fig. B)
kg 2.1
Mounting
● Mount sanding paper (8) with the required
dB(A) 77
grain size onto the sanding pad (4). Make sure
dB(A) 88
that the perforation in the sanding paper (8)
dB(A) 3
corresponds with the perforation on the
m/s 7.6
2
sanding pad (4).
m/s 1.5
2
- Use coarse sanding paper (grain 50) for
- Use medium sanding paper (grain 80) for
- Use fine sanding paper (grain 120) for
Removing
● Remove the sanding paper (8) from the
sanding pad (4).
USE
The On/Off switch Fig. A
• S witch the machine on by pressing the On/Off
switch (1). When you release the On/Off switch
(1) the machine will turn off.
Lock-on Button Fig. A
• Y ou can lock the On/Off switch (1) by pressing
the On/Off switch (1) and then pressing the
lock-on button (6).
• T o release the switch-lock; shortly press the
On/Off switch (1) again
Setting the speed (fig. A)
The speed adjustment wheel is used for setting the
speed. The speed adjustment wheel can be set to 6
positions. The ideal speed depends on the required
grain size and on the material to be worked.
2
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
sanding rough, uneven surfaces.
removing the remaining scratches from the
coarse sanding paper.
finishing surfaces.
Do not set the speed during use.