Initial Setup; What's In The Box; Placement Guidelines; Connect The System To The Pedestal - Bose WAVE SOUNDTOUCH PEDESTAL Manual Del Usario

What's in the box

Carefully unpack the box and confirm that the following part
is included:
SoundTouch Pedestal
Note: If part of the system is damaged, do not use it.
Contact your authorized Bose dealer or Bose customer
service. Visit worldwide.Bose.com/Support/WSTIV for
contact information.

Placement guidelines

To avoid interference, keep other wireless equipment 1 – 3 ft.
(0.3 – 0.9 m) away from your system. Place your system outside and
away from metal cabinets, and direct heat sources.
Connect the system to
the pedestal
The SoundTouch pedestal provides the network connection for your
Wave Music System IV.
1. Unplug your Wave music system from power.
2. Carefully set your Wave music system on top of the
SoundTouch pedestal:
• Place the rear feet of the Wave music system into the recesses
on top of the SoundTouch pedestal.
• Make sure the Wave music system sits flat and the side edges
of both parts are aligned.
IN I TIA L SET UP
Remote control
6
3. Insert the SoundTouch pedestal's cable into the
Bose link connector.

Connect the system to power

Before you set up the system on your network, connect the system
to power.
1. Insert the small end of the AC power cord into the
connector.
2. Plug the power cord into an AC (mains) power outlet.

Standby mode

If the button is not pressed after 24 hours, the system switches to
standby (off). If the 18-minute system standby timer is enabled, the
system automatically switches to standby if no audio is played and
no buttons are pressed for 18 minutes.
If the system is connected to your network when switching to
standby, the connection is maintained.
|
E N G