Pump Accessory Assembly - RIDGID VP2000 Manual Del Operador

SP6580-2 Ridgid.qxd

Pump Accessory Assembly

Your Pump Accessory will work on all
RIDGID brand Wet/Dry Vacuums that
have a drain at the bottom of the drum.
When attaching the pump to the drain of
your vacuum, you will use all of the parts
included in this kit.
1. Mount adapter onto the drain of your
Wet/Dry Vac and firmly tighten by hand.
Locate screw notch and install the
supplied #6 x 5/8-inch long screw.
NOTE: The drain adapter is now a
permanent fixture on your vacuum. Use
the original Wet/Dry Vac drain cap when
the pump is not in use.
2. Push the strainer into the large inlet of
the pump assembly. With the strainer
installed, slide the Pump Accessory
into the adapter previously installed on
the vacuum, positioning the pump in an
upright fashion. Tighten the coupler by
hand until secure.
NOTE: The connection is designed to
prohibit rotation of the pump after
installation, so proper alignment must be
achieved before the coupler has been
tightened.
3. After the pump assembly is securely
7/27/07 1:22 PM Page 6
Adapter
Pump
Accessory
Strainer
Large
Inlet
6
Adapter
Screw Notch
Screw
V a c
W e t / D r y
P u m p
y
A c c e s s o r
Coupler