Operation - RIDGID VP2000 Manual Del Operador

SP6580-2 Ridgid.qxd

Operation

To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to; lighter fluid, solvent type cleaners,
oil-base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include
but are not limited to; coal, magnesium, aluminum, grain or gun powder.
Do not vacuum explosive dust, flammable or combustible liquids or hot
ashes. Do not use this vac as a sprayer. To reduce the risk of health hazards
from vapors or dusts, do not vacuum toxic materials. Store Pump Accessory
indoors. Do not submerse pump or power cord.
!
WARNING: The operation of any
utility vac can result in foreign
objects being blown into the eyes,
which can result in severe eye dam-
age. Always wear safety eyewear
complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting
operation. Safety eyewear are avail-
able at many local retail stores.
!
CAUTION: To reduce risk of hear-
ing damage, wear ear protectors
when using the vac for extended
hours or when using it in a noisy
area.
To reduce the risk of electric shock, this
Pump Accessory has a built-in GFCI
(Ground Fault Circuit Interrupt) plug with
a ground connection. The plug must be
used on a properly-grounded outlet.
If the plug does not fit into the outlet,
contact a qualified electrician to install the
proper outlet. Do not modify the plug in
any way.
7/27/07 1:22 PM
!
WARNING
Page 8
After you plug the power cord into the
outlet, you should always test the GFCI.
Press the red "RESET" button to reset
your Pump Accessory. This has to be
done each time the pump accessory is
plugged into an outlet. If the red "RESET"
indicator does NOT pop up, your unit is
not functioning properly and you should
contact an Independent Service Center to
have your Pump Accessory serviced.
Once you have plugged the power cord
into the outlet and the tested GFCI, you
are ready to run your pump.
NOTE: The Pump Accessory should not
be operated on the same circuit as the
Wet/Dry Vac.
RESET
Button
TEST
Button
GFCI (Ground Fault
Circuit Interrupt) Plug
8
R E S E T
T E S T