Installation; Use - Powerfix Profi HG02730 Instrucciones De Montaje, De Uso Y De Seguridad

Verify the work pieces/sheet will not move on the top support
bar
Make sure that you do not load workpieces unevenly. Otherwise,
the workpiece can become unbalanced and fall down.
Remove any excess materials on the product, e.g. wet paint, dirt, oil or snow.

Installation

Note: To begin the assembly, please be reminded to only tighten all screw con-
nection slightly, and only tighten fully the screw connection when the product is
assembled completely.
First spread the leg of side frame
and lock the locking hook
the middle part of side frame
the hole on the side frame
be reminded to leave at least 3 holes to be protrude on top of the frame. Re-
peat the above steps to have 2 side frames with support bar (Fig. A).
Make sure both hole bars
Connect the middle support bar
with both side frames
Use screw set
you finish connect screw set
hooks on the screw. Use the screw sets
steps to fix the middle support bar
Connect the bottom plate
fix both bottom plates in place (Fig. D).
Place the top support bar
the top support bar
Align the product and tighten all the screw connections
Raise the two safety brackets

Use

CAUTION! RISK OF INJURY! Be sure locking hooks
secured in place. The two trestles must be set to the same working height. This
will ensure stability.
Verify the work pieces/sheet will not move on the top. If necessary, secure in
place.
Make sure that you do not load workpieces unevenly. Otherwise, the work-
piece can become unbalanced and fall down.
Always use two trestles and a board or boards together for working.
Fold the legs all the way apart.
. If necessary, secure in place.
8
on the other leg. Insert the hole bar
12
. Use the locking pin
5
in order to lock the hole bar
5
are on the same height.
7
9
(Fig. B).
5
on the side where is the locking hook
2
, pull down the locking hook
2
to the leg with screw set
6
onto the hole bar
8
in place (Fig. E).
8
on the top support bar
13
. Pull down the locking pin
5
and use screw sets
on the other side. Repeat the above
1
in place (Fig. C).
9
. Use screw sets
7
on the leg
10
through
7
and insert through
10
in place. Please
7
and to connect
1 2
on the leg. After
11
and lock the
11
. Repeat the above to
3
to fix
4
(Fig. F).
8
und are
11 12
GB/IE 13