Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OpERatInG InStRuCtIOnS
fInDInG fauLtS In CaBLE
The tester may be used for finding faults in some flexible cables. Turn the
5
sensitivity selector knob
to the appropriate setting for the energized cable
being detected. Move the detector along (but not touching) the cable, listening for
rapid beeping or steady sound and looking for the rapidly blinking or steady red
1
light from all 3 LEDs
. When the fault is reached, the unit will no longer beep
or blink. See Fig. 2 on page 5. Always maintain the minimum approach distances
listed in OSHA Tables R-6 and R-7 on pages 8 & 9 in this manual.
7
Publicidad
Tabla de contenido
