Speedlink SL-6580 Manual Del Usuario página 15

Macro function
The macro function enables you to assign any sequence of button commands to a single button.
Buttons L1,L2, R1 and R2 can be assigned a macro function.
1. Press the macro button. The red LED starts flashing.
2. Press one of the following buttons to which you wish to assign the macro function: L1,L2, R1 or R1.
3. Press the required sequence of commands, e.g. X,O,X,
4. Press the macro button again to finish the process. The LED goes out.
5. Press the macro button again to delete the programming.
Analogue/digital mode
The analogue button allows you to select between analogue and digital modes.
Red LED on = analogue mode
Red LED off = digital mode
LEDs
Signal LED (red) on gamepad and receiver:
The LED lights red on the gamepad and receiver or flashes when signals are transmitted.
Power LED on receiver:
The power LED lights red when the gamepad is working properly.
Link LED on receiver:
When the LED lights red, the connection between gamepad and receiver is working properly. When the LED
flashes, the connection between gamepad and receiver is faulty.
Troubleshooting
The gamepad is not recognised properly.
1. Connecting to the PC: don't connect the gamepad to the PC via a USB hub, only directly to the USB port
of the PC.
2. Connecting to the PC: don't connect the gamepad during a system start of the PC, wait until the PC has
finished start-up.
The gamepad is not responding.
• Make sure there is nothing between gamepad and receiver that could obstruct the radio connection.
15
D
GB
F
E
I