Removing The Refrigerator Doors - Samsung RF323TE Manual Del Usuario

When moving your refrigerator
To prevent floor damage, be sure the front
adjusting legs are in the up position (above
CAUTION
the floor). Refer to 'Adjusting the Level' in
the manual (on page 9).
Flat-blade screw
Control Lever
driver(-)
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor. This surface
should be strong enough to support a fully loaded
refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
DA68-02603A-10.indb 7
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don't need to. If you
do not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
WARNING
• Be careful not to drop, damage, or
scratch the door/drawer while removing
them.
• Use care when you remove the doors/drawer.
The doors are heavy and you could injure
yourself.
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the
doors while removing them.
WARNING
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips Flat-blade screw
screwdriver(+)
Pliers
English - 7
Socket wrench
driver(-) (10mm)
Allen wrench
(3/16") (5mm)
2015. 11. 5. 5:02