Beta 1498TB Instrucciones página 17

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
10. Premete "EXIT" per tornare al passo 3 o rimuovere le pinze di test dai poli della batteria per terminare il test.
START SYSTEM TEST - "STARTER TEST"
1. Clamp the black lead to the negative terminal of the motor vehicle battery. Clamp the red lead to the
positive terminal of the motor vehicle battery.
2. Press ▼▲ to select "Starter Test". Press "Enter" to confirm selection.
3. The following screen will appear:
Battery: xxxV
Crank the engine until it starts. Press "Enter" to proceed.
4. When the engine is started, one of the three results will be shown along with the reading of the
measured voltage.
Result: OK
The system shows normal Starting Voltage. Press "EXIT" and "Alternator Test"
to test the charging system.
Result: Abrupt Voltage Drop
The starting voltage is below normal limits; find the starter motor fault following
the manufacturer's recommended instructions.
Result: Not Detected
The starting voltage was not detected.
ALTERNATOR TEST" WITH ELECTRIC LOADS OFF
1. If the starting voltage is normal, press "EXIT" and "Alternator Test" to
perform the charge system test. Select alternator type: "Normal" or "Smart".
Switch off all the accessories of the motor vehicle being tested, including
lights, air conditioner and radio, before starting the engine.
2. Press "Enter" to view the following screen:
Start the engine and keep it running.
Press "Enter" to proceed.
3. The following screen will appear:
Press "Enter" to proceed. Rev the engine up to 3,000 rpm for 10 seconds; then
press "Enter" again to view the results.
4. The following screen will appear:
Select Test▲▼
Battery Test
Grounding Test
Starter Test
Alternator Test
Battery: xx.xxV
Crank engine
until it starts
Result: OK
Min. Volts: xx.xxV
Volt Drop: Normal
Result: High Voltage Drop
Min. Volts: xx.xxV
Volt Drop: High
Check starter relay, battery
terminals or battery age.
Result: Not detected
No change in volt drop. Check
clamping at battery and test again.
Select Test▲▼
Battery Test
Grounding Test
Starter Test
Alternator Test
Start engine
and keep it running.
[Enter] to proceed
Make sure all electrical loads are
turned off. Rev engine up to 3,000
rpm
Press [Enter].
Hold on to 3,000 rpm for 10
seconds, then release pedal.
At 3,000 rpm:
Average Volts: xx,xV
Max. < xx,xV: xx,xV
Min. > xx,xV: xx,xV
EN I
17