AQUARAY MultiControl 8 Instrucciones De Operación página 5

Operation
Once mounted and connected according to the
installation instructions above, the PSU may be
switched on. The screen will display 'PLS W IT'
while it initialises. Once it has entered 'RUN'
mode (i.e. the clock is displayed) you may
program the unit as detailed below:-
• Pressing the MODE button will cycle through
the available modes (see table overleaf). If no
button is pressed for 10 seconds, the quaRay
MultiControl unit will return to 'RUN' mode.
• Holding a button down will cause an auto-repeat
of that button.
• Pressing '+' in 'RUN' mode will advance
Channel 1 to the next phase. The phases are;
OFF, R MP UP, ON and R MP DOWN.
• Pressing '-' in 'RUN' mode will initiate the
'Storm Function' (see later in this booklet for
details of this function). Pressing '-' whilst in
'Storm Function' will exit and resume the user
set program.
• Lamps start to brighten when the ON TIME
equals the current time.
equivalent to 1 minute before lamps are at full
brightness.
R MP time of 1 is
3