Publicidad
Idiomas disponibles
Idiomas disponibles
6. Clean cable
Using an approved solvent, clean and degrease the damaged area
and the cable on either side of the damage as shown. Remove any
sharp points from the area to be covered with CRSM.
7. Center sleeve; mark cable
Center sleeve over damaged area. Mark the cable as shown.
Remove the release paper from the CRSM.
8. Slide channel(s) over rails
Butt the rails together and slide the channel over the rails. Center
sleeve between marks.
Channel(s) must extend beyond the sleeve edge as shown.
9. If two channels are needed, install channel clip
Connect the two channels with the short channel retention clip as
shown. Use pliers to install the clip.
10. Shrink sleeve
Preheat the metal channel area for approximately 30 seconds.
Continue shrinking at the center (1), working torch with a smooth
brushing motion around the sleeve. After the center portion shrinks,
work torch as before toward one end (2), then to the opposite end (3).
11. Post-heat sleeve
Post-heat the entire length, concentrating on the metal channel area,
until the CRSM conforms tightly to the cable, without wrinkles, and
adhesive flows from each end.
This completes the installation.
Allow to cool before moving or placing in service.
The Information contained in these installation instructions is for use only by installers trained to make electrical power installations and is intended to describe the correct method
of installation for this product. However, Tyco Electronics Corporation has no control over the field conditions which influence product installation. It is the user's responsibility to
determine the suitability of the installation method in the user's field conditions. Tyco Electronics' only obligations are those in Tyco Electronics' standard Conditions of Sale for this
product and in no case will Tyco Electronics be liable for any other incidental, indirect or consequential damages arising from the use or misuse of the products.
TE (logo) and Tyco Electronics are trademarks. Copyright 1995, 2010 Tyco Electronics Corporation. All Rights Reserved.
PII 51068
Revision AD
6"
(150mm)
Mark
CRSM
1/4"
(5mm)
Black Wraparound Sleeve
2
3
Clean
6"
Damage
(150mm)
Mark
1/4"
Channel
Clip
1
3
PCN 121979-000
Effective Date: October 19, 2010
248
250
(5mm)
251
252
253
254
Publicidad
