Before First Use; Filling The Water Tank - MPM MKD-03 Manual De Usuario

BEFORE FIRST USE

1. Unpack the ice cube maker and remove all plastic bags, labelling stickers, filling materials and
transport locks.
2. Inspect for transport damage. If you suspect that the ice cube maker is damaged, do not use
it. Consult the seller.
3. Place the ice cube maker on a firm, dry and stable surface, away from sources of heat and
direct sunlight, to maximize its performance. Keep a clearance of 20 cm minimum around the
ice cube maker to provide proper ventilation.
CAUTION! Do not use the ice cube maker outdoors.
CAUTION! Do not use the ice cube maker at extremely low or high temperatures. If the ambient temperature is
below 10°C or above 43°C, making ice cubes will be difficult.
4. Before using the ice cube maker, leave it at the room temperature for at least 2 hours after
delivery. The ice cube maker needs this time to reach the ambient temperature and stabilize
its refrigerant. If you move the ice cube maker, wait at least 30 minutes before turning it on.
5. Verify that your power mains match the nameplate ratings of the ice cube maker. Plug the ice
cube maker to power outlets with a PE terminal only.
6. The ice cube maker makes ice cubes intended for human consumption. You need to clean
the ice cube maker before the first use, see Section "CLEANING AND MAINTENANCE".

FILLING THE WATER TANK

1. Make sure that the ice cube maker is unplugged from the mains.
2. Lift the lid (3), remove the ice cube bucket (10), and fill the water tank (5) with no more than
1.0 litre of water at an ambient temperature. Do not spill the water on the housing.
CAUTION! Do not fill the water tank over the max water level. Use clean potable water only.
3. Install the ice cube bucket (10) and make sure that the level of water in the tank is below the
bottom of the ice cube bucket (10).
4. Close the lid (3).
USING THE ICE CUBE MAKER
1. Having properly positioned the ice cube maker and filled it with water, plug it into the mains.
The ice cube maker will beep, and the WORK indicator (4d) will be flashing.
2. Press the ON/OFF switch (4a). The ice cube maker will start making ice, while the WORK indi-
cator (4d) will steadily on.
3. Within 15 minutes, the ice cube maker will reach a correct operating temperature and start
making the first ice cubes. As long as the ice cube maker is turned on, it will continue making
6 ice cubes every 6-13 minutes, depending on the ambient temperature.
4. Inspect the ice cube making process through the viewport (2). When the ice cube bucket (10)
is completely filled with ice cubes, the ICE FULL indicator (4b) will start flashing, and there
will be a series of short beeps. Remove the ice cube bucket (10), store the ice cubes in a cool
place and put the ice cube bucket (10) back in the ice cube maker. The ice cube maker can
14