Home Decorators Collection 51504 Guía De Uso Y Cuidado página 10

Assembly - Hanging the Fan (continued)
5
Wiring the receiver to the household
wiring
WARNING: To avoid possible electrical shock, turn the
electricity off at the main fuse box before wiring. If you
feel you do not have enough electrical wiring knowledge or
experience, contact a licensed electrician.
WARNING: Each wire nut supplied with this fan is designed to
accept up to one 12-gauge house wire and two wires from the
fan. If you have larger than 12-gauge house wiring or more
than one house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.
IMPORTANT: Use the wire connecting nuts (BB) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
□
Spread the wires apart so that the green and white wires
are on one side of the outlet box and the black wire is on the
other side.
□
Connect the green fan wires to the household ground wire
(this may be a green or bare wire) using a wire connecting
nut (BB).
□
Connect the receiver (M) red wire to the household black
(hot) wire using a wire connecting nut (BB).
□
Connect the receiver (M) white wire to the household white
wire (neutral) using a wire connecting nut (BB).
□
Secure each wire connecting nut using electrical tape.
BB (x3)
Black
Red
Receiver
Antenna
ON DIP
1 2 3 4
Receiver (M)
Outlet Box
in the ceiling (MM)
Green (or Bare)
Green
White
6
Wiring the fan to the receiver
IMPORTANT: Use the wire connecting nuts (BB) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
IMPORTANT: If after this step, you decide to check that the
electrical connections have been successful, it is critical to
attach the light kit using the quick connector prior to testing.
The fan will not operate unless the light kit is connected to the
fan.
NOTE: The fan comes with 54 in. lead wires for use with an
extended ball/downrod assembly. If using the 6 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 13.5 in.).
□
The fan comes with 54 in. lead wires for use with an
extended ball/downrod assembly. If using the 6 in. ball/
downrod assembly (B) provided, you can cut the lead wires
to your desired length (no shorter than 13.5 in.) This will
make extra room in the canopy (C), if you do not wish to cut
the wires, you will need to neatly wrap them.
□
Connect the fan motor white wire to the receiver white wire
using a wire connecting nut (BB).
□
Connect the fan motor black wire to the receiver black wire
using a wire connecting nut (BB).
□
Connect the fan motor blue wire to the receiver blue wire
using a wire connecting nut (BB).
□
Secure each wire connecting nut using electrical tape.
□
Turn the wire connecting nut (BB) upward and push the
wiring into the outlet box (MM).
Receiver (M)
Receiver
Antenna
BB (x3)
10
Green
ON DIP
1 2 3 4
Blue Black White
Outlet box
in the ceiling
(MM)