Teach-In To Alpha Ip Access Point - Alpha IP RTA 61001-N1 Manual Del Usario

Ocultar thumbs Ver también para RTA 61001-N1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 98
Commissioning
1. Select the desired channel at the Alpha IP base station (see Alpha IP Base station
instructions).
2. Activate the teach-in mode at the base station by pressing and holding the key.
9 The device LED starts to flash in orange.
3. Take off the room control unit Analog from the installation bottom (see page
5, fig. 3).
4. Pull out the insulating strip from the battery compartment, or insert batteries
(see page 5 fig. 4). If batteries have already been inserted, press the system key
(C) for at least 4 seconds in order to activate the teach-in mode.
9 The teach-in mode is activated automatically for 3 minutes.
9 The device LED flashes in orange.
The LED will light up in green after a successful teach-in process. If the LED
lights up red, repeat the process.

5.1.2 Teach-in to Alpha IP Access Point

For a control via the Alpha IP app, the teach-in must of the RTA 61001-N1 must be
performed via the Access Point (HAP 21001). Teach-in the device as follows:
Ö The Alpha IP Access Point has been set up via the Alpha IP App (see instructions
HAP 21001).
1. Open the Alpha IP app on the smart phone.
2. Select the menu item Teach-in device.
3. Release the room control unit Analog from the installation bottom (see page 5
fig. 3).
4. Pull out the insulating strip from the battery compartment, or insert batteries (see
page 5 fig. 4) If batteries have already been inserted, press the system key (C) for at least
4 seconds in order to activate the teach-in mode.
32

Publicidad

Tabla de contenido
loading

Tabla de contenido