Publicidad
Idiomas disponibles
Idiomas disponibles
Technical specifications
GENERAL SPECIFICATIONS
Frequency range
Number of channels
Channel spacing
Frequency stability
Antenna impedance
Operating voltage
Charging time
Dimensions
Weight
Usage temperature
Storage temperature
TRANSMITTER
Power output
FM modulation mode
Adjacent
Modulation limit
Audio distortion
RECEIVER
RF sensitivity
Audio distortion
Audio response
Adjacent selectivity
Audio output
Charging the battery
Charge the battery before first using the device. A new battery, or one stored
for more than two months, reaches its full capacity after 2 or 3 charges and
discharges.
5-
Plug the adapter into the mains. The LED turns green.
6-
Insert the walkie-talkie or the battery alone into the battery charger.
7-
Ensure that the battery is correctly in place and that the charge terminals are
properly connected. The LED indicator flashes red. Charging begins.
8-
After around 4 hours, the LED indicator turns green, indicating that charging is
complete.
Caution:
3-
Do not recharge the battery if it is already fully charged. This can shorten the
battery life or even damage the battery.
4-
If the battery temperature is too high (over 60°C), charging is stopped. Wait for the battery temperature to go down
to start recharging it again.
Inserting and removing the battery
The time between battery charges is around 8 active hours. This value is obtained for a standard cycle of 5% transmission,
5% active reception and 90% standby time.
The images below show how to insert and remove the battery.
Caution:
Do not short-circuit the battery terminals or throw the battery into a fire. Never try to remove the battery casing.
TLK1022 – indice A
TLK1022 Walkie-Talkie
PMR446 MHz (UHF)
16
12.5 KHz
±2.5 ppm
50Ω
3.7V DC
Around 2h
117mm x 60mm x 35mm (without antenna)
205mm x 60mm x 35mm (with antenna)
170g with battery
-30°C to +60°C
-40C to +85°C
500 mW ERP
F3E
65 dB (narrow)
±2.5 KHz / 12.5 KHz
<5%
0.2 µV (12 dB SINAD)
<5%
+1 to -3db
60 dB / 12.5 KHz
0.5 W
8/32
Publicidad
