Replacement Parts - Eaton Crouse-Hinds Champ FMVA LED Serie Manual De Instalación Y Mantenimiento

DIMENSIONS
With Visor and Guard
VISOR INSTALLATION INSTRUCTIONS
(catalog number DSV2)
1. Remove power from luminaire.
2. Place luminaire face up.
3. Carefully align visor with four (4) screw holes at the top of the fixture shown in
Figure 9.
4. Install screws provided with visor, taking care to not scratch the finish of the
luminaire. Torque to 19 in.-lbs. (2.2 N-m).
5. Install luminaire per above instructions.
NOTE: Visor can be installed before or after luminaire has been in operation.
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or completeness thereof are not guaranteed. In accordance with Crouse-
Hinds "Terms and Conditions of Sale," and since conditions of use are outside our control, the purchaser should determine the suitability of the product for his intended use and assumes all risk and liability whatsoever in
connection therewith.
Figure 7
With Visor Only
Figure 9
Figure 6
With Guard Only
GUARD INSTALLATION INSTRUCTIONS
(catalog number P62)
1. Remove power from luminaire.
2. Place luminaire face up.
3. Carefully align guard with four (4) screw holes on each side of the luminaire
shown in the image above.
4. Install screws provided with guard, taking care to not scratch the finish of the
luminaire. Torque to 19 in.-lbs. (2.2 N-m).
5. Install luminaire per above instructions.
NOTE: Guard can be installed before or after luminaire has been in operation.
MAINTENANCE
• Perform visual, electrical and mechanical inspections on a regular basis. The
environment and frequency of use should determine this. However, it is
recommended that checks be made at least once a year. We recommend an
Electrical Preventive Maintenance Program as described in the National Fire
Protection Association Bulletin NFPA 70B: Recommended Practice for Electrical
Equipment Maintenance (www.nfpa.org).
• The lens should be cleaned periodically to ensure continued lighting performance.
To clean, wipe the lens with a clean, damp cloth. If this is not sufficient, use a
mild soap or a liquid cleaner such as Collinite NCF or Duco #7. Do not use an
abrasive, strong alkaline or acid cleaner. Damage may result.
• Visually check for undue heating evidenced by discoloration of wires or other
components, damaged parts or leakage evidenced by water or corrosion in the
interior. Replace all worn, damaged or malfunctioning components and clean
gasket seals before putting the luminaire back into service.
• Electrically check to make sure that all connections are clean and tight.
• Mechanically check that all parts are properly assembled.

REPLACEMENT PARTS

Crouse-Hinds Champ LED Luminaires are designed to provide years of reliable lighting
performance. However, should the need for replacement parts arise, they are available
through your authorized Crouse-Hinds distributor. Assistance may also be obtained
through your local Crouse-Hinds Sales Representative or the Crouse-Hinds Sales
Service Department, 1201 Wolf Street, Syracuse, New York 13208, Phone 866-764-
5454.
Eaton's Crouse-Hinds Division
1201 Wolf Street, Syracuse, New York 13208 • U.S.A.
Copyright 2020
©
Figure 8
Supercedes 09/19
IF 1883
Revision 3
Revised 02/20