Publicidad
Idiomas disponibles
Idiomas disponibles
Drill pump for water
Operating instructions
1. Fix the water pump on the board with two suitable
screws as shown in the figure below:
2. Use the 3/4" garden hose to connect to the drill pump.
3. Insert the pump hose into the frame mandrel and adjust
accordingly, as shown in the figure.
The drill pump will work when you start the hand drill,
please confirm whether the steering of the hand drill is
consistent with that of the drill pump.
Pay attention to the direction of inlet and outlet, make sure
to submerge the water inlet at least 0.019"
When stored for a long time for the first time use, please
add the grease into the impeller.
CAUTUION
• The maximum speed of the pump is 2 800 rpm. We
recommend that you use in more than 700 W power drill .
• The pump's self-suction is up to 8 feet (when the
impeller is greased).
• The pump cannot be turned dry, otherwise the pump will
be damaged.
This product is guaranteed for 10 years. To make the warranty valid or purchase parts and components you must present the
product in Corregidora 22, Col. Centro, Alc. Cuauhtémoc, CDMX C.P. 06060 or at the establishment where you purchased it,
or at any Truper® Service Center listed in the annex to the warranty policy
and/or in www.truper.com
For questions or comments, call 800-690-6990. Made in China. Imported by
Truper S.A. de C.V. Parque Industrial 1, Jilotepec, Edo. de Méx. C.P. 54240
• Please apply grease to the impeller surface according to
the operation method shown below before each use:
• Remove the 6 screws.
• Remove the cover plate, pay attention to an O ring
don't fall off.
• Please apply grease to the impeller position as shown
in the figure.
• We suggest using lithium base grease.
• Please start the water pump after fixing it reliably. Don't
hold water pump with the hand and open it.
• Pump can not pump flammable explosive liquid.
Operation diagram
Water
10-2020
Hose
Pump
Delivery date:
100778
BOT-1
Manual
Drill
Hose
Water
Publicidad
