Manuales relacionados para Truper MOTB-4X
Resumen de contenidos para Truper MOTB-4X
- Página 1 Manual Water Pump Agricultural Use Applies for: Code Model 102405 MOTB-4X MOTB-4X Read this manual thoroughly CAUTION before using the tool.
- Página 2 Contents CAUTION Technical Data Fuel Specifications To gain the best performance of the tool, prolong the duty life, General Safety Warnings for Motor Tools make the Warranty valid if necessary, and to avoid hazards Safety Warnings for Water Pumps of fatal injuries please read and understand this Manual before Parts using the tool.
- Página 3 Technical Data MOTB-4X Code 102405 Description Water Pump Motor Cylinders 420 cm (cc) Motor Rated Power 15 Hp Motor Type 4-stroke OHV No Load Speed 3 650 RPM - 3 700 RPM Fuel Gasoline Gas Tank Capacity 1.5 gal Fuel Yield at 100% Fill Up...
- Página 4 General Safety Warnings for Motor Tools Keep your work area clean, tidy and well lit. Wear adequate protective safety accessories. CAUTION CAUTION Cluttered and dark areas may cause accidents. Wear eye protection, dust mask, non-skid safety shoes, helmet and ear plugs. These safety gears reduce the risk Never use the tool in explosive areas or in the presence of injury.
- Página 5 Safety Warnings for Water Pumps Appropriate use Fuel Handling • Do not use the pump to pump flammable or corrosive • Never smoke close to where there is fuel, nor the liquids such as gasoline, oils and acids, neither pumping filling up zone or when operating the pump.
- Página 6 Parts Fuel Tank Cap Water Purge Outlet Exhaust Air filter cover Spark Plug Water Inlet Oil Supply Water Drain Pump Tubular Chassis Water Outlet Choke Throttle Lever Water Inlet Fuel Key Oil Supply Cap Starter jack-line Start Oil Drain Cap Knob ENGLISH...
- Página 7 Assembly Coupling Mounting • Insert the coupling (A) in the screw (B) as shown in figure . • Set the seal (C) in the coupling . • Screw the screw in the inlet / outlet of the pump (D). Inlet Coupling Outlet Coupling...
- Página 8 Set Up • Place the equipment on a dry, firm, flat and leveled surface. • Connect one end of the suction hose (not included) to the pump water inlet (A), and the other end of the hose to the filter (B). •...
- Página 9 Fuel and Oil Oil Supply (A) Fuel Supply (B) • Set the equipment onto a flat and leveled surface. • Set the Pressure Washer on a flat and leveled surface. • Turn and remove the oil supply cap. • Clean and dry the area around the fuel cap. •...
- Página 10 Start Up Purge • The system shall be purged of any air bubble by filling the pump with clear water before starting. • Remove the purge cap (F). Fill up with water up to the orifice level and screw back the cap. Only then the pump can be started.
- Página 11 Maintenance CAUTION • Regular and careful maintenance is • Any worn or damaged part shall be replaced before essential to maintain the safety levels and the optimal using the equipment. Do not try to repair the parts. It can performance of the equipment. damage the equipment and become a risk to your safety.
- Página 12 Maintenance Fuel Filter Spark Plug • The fuel filter stops water or dirt present in the fuel • Before removing the spark plug (B), wipe clean the area tank to enter into the carburetor. around the spark plug base to stop dust and debris If the motor has not been run after a long period of time, entering the motor.
- Página 13 Troubleshooting Problem Cause Solution Motor does not start. • The switch is OFF. • Turn ON the switch. • Not enough fuel. • Fill up fuel tank. • Oil level is too low or there is no oil. • Check oil level as indicated in page 9. •...
- Página 14 Notes ENGLISH...
- Página 15 In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center. DE TODO PARA LA CONSTRUCCIÓN FIX FERRETERÍAS...
- Página 16 Phone number 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.