Tabla De Contenido; Table Of Contents; Safety Information; Warranty - HAMPTON BAY IYG8011L-2/CR U Guía De Uso Y Mantenimiento

Interior led de empotrar
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Table of Contents

Table of Contents ....................................... 2
Safety Information ..................................... 2
Warranty ........................................................ 2
What is Covered......................................... 2
What is Not Covered...................................2
Pre-installation ............................................ 3
Planning Installation...................................3

Safety Information

WARNING: Carefully read and understand the
information given in this manual before beginning the
assembly and installation. Failure to do so could lead to
electric shock, fire or other injuries which could be
hazardous or even fatal.
WARNING: Be sure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn the
circuit off.
NOTICE: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.

Warranty

WHAT IS COVERED

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of
five (5) years from date of purchase. This warranty applies only to the original consumer and only to products used in
normal use and service. If this product is found to be defective, the manufacturer's only obligation, and your
exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.

WHAT IS NOT COVERED

This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any
way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of
the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other
failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the
product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for
a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability
and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labor /
expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.HamptonBay.com
Tools Required........................................... 3
Hardware Required.................................... 3
Package Contents...................................... 4
Installation .................................................... 5
Care and Cleaning ..................................... 7
Troubleshooting ......................................... 7
NOTICE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido