Battery Replacement
1. Use 2 x CR2032 lithium batteries only.
2. Open the battery cover on the back of the scale by pushing the tab in the direction
of the "open" arrow and lift up.
3. Insert a small screwdriver into the slot holding bracket and carefully pry up the
battery until it pops out.
4 Place the new batteries with the "+" sign up on an angle with one side under the
tabs and push down.
5. Close the battery cover. Be sure it clicks shut.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc)
batteries.
• Clean the battery contacts and als.o those of the device prior to battery installa-
tion
• Remove used batteries promptly.
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
NOTE: Please recycle or dispose of batteries per local regulations.
WARNING: Batteries may pose a choking hazard. Do not let children handle
batteries.
Low Battery
This scale is equipped with a low battery indicator. Replace the battery when "Lo" is
displayed or readings grow dim or become irregular.
Trouble Shooting
In case of difficulty:
1. Move your scale to a location where it will not be bumped. If your scale is bumped
while being activated or while in use, an inaccurate reading may occur. Initialize the
scale as described in FIRST TIME SETUP #4.
2. Make sure the batteries are properly installed.
+
CR 2032
CR 2032
BATTERY PRECAUTIONS
4
+