Cherry Power WheelMouse Manual De Instrucciones página 8

The data transfer between the mouse and the
receiver is indicated by the LED briefly flashing.
Following a battery change, the individual signal
transfer must be reactivated.
How to deactivate the individual signal transfer
between the mouse and the receiver
1 Press the button on the receiver for approx.
5 seconds.
The LED of the receiver lights up dimly. The indi-
vidual signal transfer is deactivated.
The data transfer between the mouse and the
receiver is indicated by the LED briefly flashing
brightly.
6 Activating and using the power
management function
The power management function of the Cherry
Power WheelMouse wireless optical switches
the mouse off completely after a 15 minute period
in which the mouse is not moved. This consider-
ably increases the battery life.
How to activate the power management func-
tion
1 Remove the batteries.
2 Simultaneously press and hold the left mouse
button and the Start button (button on the left-
hand side) and reinsert the batteries.
Following a battery change, the energy-saving
mode must be reactivated.
How to reactivate the mouse in the energy-
saving mode
If the mouse has not been moved for longer than
15 minutes, you must switch it on manually.
1 Press any button.
The mouse is ready to operate.
When the power management function is inactive,
the mouse is in the Sleep mode, which saves less
energy. After a period of 15 minutes without move-
ment, the surface under the mouse is only scanned
a few times per second. Moving the mouse or
pressing a button ends the Sleep mode.
7 Installing the mouse under
Windows 95/98/ME/NT4/2000/XP
To install the software underWindows 95/98/
ME/NT4/2000/XP
1 Place the enclosed CD-ROM in your
CD-ROM drive.
The CD-ROM starts automatically. The Cherry
Power WheelMouse optical window is opened.
- OR -
If the CD-ROM is not started automatically,
select CD-ROM Drive | Software in the Win-
dows Explorer and double-click the file
Setup.exe with the left mouse button.
Installation begins.
2 If the CD-ROM starts automatically, click on the
entry Start software installation.
Depending on the settings of your Internet
Browser you can save or open the file.
• If possible, select the option Open and click on
the OK command button.
Installation begins.
• If only the option to save the file exists, cancel
the dialog box, select CD-ROM drive | Soft-
ware in the Windows Explorer and double-click
with the left mouse button on the file
Setup.exe.
Installation begins.
3 Follow the installation instructions on the screen.
7