Thrust Jet Adjustment; Sweep Hose Adjustment; Routine Maintenance - Polaris Vac-Sweep PRO 480 Manual Del Propietário

Fine Tuning The Polaris Cleaner
When operating correctly, the Polaris 480 vacuums, sweeps and scrubs all surfaces
randomly throughout the pool. The climbing ability of the Polaris depends on the pool's shape
and water pressure or flow. The Polaris climbs best in pools without sharp angles or curves in
the transition from the pool floor to the pool wall.
Approximately every 3 minutes the Polaris 480 goes into back-up mode. This action pulls the
Polaris away from pool obstacles and increases its random pattern.

Thrust Jet Adjustment

The thrust jet powers the direction of the
Polaris. Factory position is straight back, but
depending on the pool, other settings
are helpful.

Sweep Hose Adjustment

The sweep hose should move in a
gentle sweeping motion. To increase
or decrease the motion of the sweep
hose, turn off the booster pump and
change the sweep hose settings.
There are five easy-click settings
located at the back of the cleaner.
See Troubleshooting for other
action adjustments.

Routine Maintenance

Cleaning the All-Purpose Filter Bag
Depress the bag clasp to free the bag from the feed hose. Depress the prongs to release the
bag from the cleaner. Open the bag closure and remove the debris.
Zipper
Closure
Sweep Hose Settings
Whenever possible, empty the filter
bag when it is half full, especially if
the dirt load is sand.
It is easier to empty the filter bag
when it is dry. Alternate between
two filter bags. When one becomes
full, remove it and put on the
clean bag.
www.polarispool.com
12
9 3
6
Sweep Hose Jet
Thrust Jet