Introduction; Safety Precautions/Warnings - Innova 3340 El Manual Del Propietario

Ocultar thumbs Ver también para 3340:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION

Congratulations. You have purchased a precision instr ument
manufactured to the highest quality standards . This Digital
Automotive Tester is a general-purpose instrument designed
for use in gener al electronics, home electr ical applications,
and automotive electrical/electronic systems.
This tester is designed to test or measure AC voltage, DC
voltage, DC current, AC current, resistance, diodes, continu-
ity, frequency, duty cycle, pulse width, rpm and temperature.
Please take the time to read these operating instructions thor-
oughly and completely. Failure to follow these instructions may
result in electrical shock, instrument damage and/or damage
to the equipment under test.
when working on or around electrically operated equipment.
SAFETY PRECAUTIONS/
Do not operate this tester bef ore reading this man ual in its
entirety. The following guidelines must be followed to avoid acci-
dents that can result in electr ic shock or personal injury.
Pay close attention to
and rear of the tester' s case. These warnings, as well as all
warnings and precautions used through out this manual, must
be followed to avoid electric shock and/or personal injury.
The RESPONSIBLE PARTY shall be made aware that, if the
equipment is used in a manner not specified b y the man u-
facturer, the protection pro vided by the equipment ma y be
impaired.
Before using an y of the functions on this tester , verify its
proper operation on a kno wn similar function source where
the unit value is also known. Take corrective action based on
the indicated results.
To prevent electrical shock and/or damage to the tester or the
equipment under test, observe the following safety precautions:
DO NOT apply more than the r ated voltage, as mar ked on
the tester, between terminals or betw een any terminal and
earth ground.
Use caution when working above 30V AC rms, 42 V peak, or
60 V DC. Such voltages pose a shock hazard.
To avoid false readings that could lead to possib le electric
shock or personal injury, replace the batteries as soon as the
low battery indicator
Always use e xtreme caution
WARNINGS
WARNINGS stamped on the front
displays.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido