Black and Decker PSV1800 Manual De Instrucciones página 6

90528647 01 PSV1800 PIVOT CRDL VAC
M
O
12
12
ASSEMBLY
Assembly tools required (not supplied)
• Phillips screwdriver
ATTACHING HANDLE TO UNIT (FIGURE A)
• Align the D-handle with the main body of the unit and push it down until it is fully seated
as shown in figure A.
• Remove the phillips head screw from the plastic bag.
• Insert the screw into the hole indicated by the arrow in figure A.
• Tighten screw securely using a phillips screwdriver.
CHARGING BASE (FIGURE B)
• Place the charging base (6) on the floor, convenient to an electrical outlet. The
PSV1800 stores and charges in the base whenever it is not in use.
WARNING: Falling/Tripping Hazard. Do not place charging base on any elevated
surface. The product is designed to be placed into and removed from the charging
base when it is sitting on the floor convenient to an electrical outlet.
OPENING THE VACUUM (FIGURES C - H)
• To open the vac for use, lift it from the charging base (6) (figure C).
• Push back the pivot lock trigger (3) on the handle and rotate the vacuum head
(figure D).
10/16/08 7:47 AM Page 6
N
10
6
11