Publicidad
Idiomas disponibles
Idiomas disponibles
Note
•
If using the reference for wall mounting (on the last page of this guide), make sure
to measure the actual space for 463 mm and 192 mm as those spaces are
abbreviated (the space for 87 mm is as indicated on the reference).
•
As indicated above, do not tighten the screws fully. You will tighten the screws in
step 6.
•
The pull-out strength of the installation area must be at least 294 N (30 kgf) per
screw.
2.
Fix the Top Bracket to the left side of the PBX with 3 screws (B). (Recommended
torque: 0.8 N·m [8.2 kgf·cm] to 1.0 N·m [10.2 kgf·cm])
Screw (B)
3.
Fix the Bottom Bracket to the right side of the PBX with 3 screws (B). (Recommended
torque: 0.8 N·m [8.2 kgf·cm] to 1.0 N·m [10.2 kgf·cm])
4.
Place the PBX onto the wall, making sure that the guide holes hook onto the screw
heads.
Screw (B)
3
Publicidad
