Operating Chain Saw; Filling Oil Tank; Oiling Chain - Remington M12510US El Manual Del Propietario

SAW CHAIN TENSION
ADJUSTMENT
Continued
❸
Turn chain tensioning screw
clockwise to tension saw chain...
❹
Guide Bar
Pull chain to check tension. Guide links
should not come out of guide bar
groove...
❺
Make sure chain moves freely around
guide bar then tighten nut.
113005

OPERATING CHAIN SAW

FILLING OIL TANK

1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil. Note: For
3. Replace oil cap at once. Tighten oil cap firmly for
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw is not in
use. Empty oil tank after each use to prevent seepage.

OILING CHAIN

Approx.
Manual Oil System
1/8"
Always check oil level before using saw. Do not at-
tempt to operate the oil system while saw is in op-
eration. To oil chain, press squeeze bulb. Oil will
feed onto the guide bar and chain. Press squeeze bulb
at least once before each cut. Check oil level often
by looking at oil level through side of oil bottle (see
Figure 9).
Figure 9 - Oil Squeeze Bulb and Oil Bottle
Location
9
WARNING: Read and understand this
owner's manual before operating this saw.
Make certain you read and understand all
Important Safety Information, pages 3
through 5. Improper use of this chain saw
can cause severe injury or death from fire,
electrical shock, or body contact with mov-
ing chain, or falling wood.
temperatures below 30°F, use SAE #10 oil. For
temperatures above 75°F, use SAE #40 oil.
good seal. This will avoid oil seepage from tank.
Oil Bottle
Oil Squeeze Bulb
Continued
www.desatech.com