Replacing Saw Chain - Remington M12510US El Manual Del Propietario

CLEANING AND
MAINTENANCE
Continued
Items Needed to Sharpen Chain
Purchase these items from your local dealer, hard-
ware store, or chain saw supplies outlet.
• 5/32" round file
• Depth gauge tool
• File guide
• Vise
• Medium sized flat file
Sharpening Cutters
Use file guide for 30° filing.
1. Adjust chain for proper tension (see Saw Chain
Tension Adjustment, pages 8 and 9).
2. Clamp guide bar in vise to hold saw steady. Note:
Do not clamp chain.
3. Press 5/32" round file (attached to file guide) into
groove between top plate and depth gauge on
chain. File guide should rest on both top plate
and depth gauge (see Figure 22). Note: File at
midpoint of guide bar.
30° Guide Mark
Note: This illustration shows file guide placement and filing
direction for sharpening cutters on left side of chain.
Figure 22 - File and File Guide Placement On
Chain
Depth Gauge (left
side of chain)
Groove
Top Plate (left
side of chain)
Figure 23 - Chain Part Locations
www.desatech.com
Filing Direction
File Guide
5/32" Round
File
Depth Gauge (right
side of chain)
Groove
Top Plate (right side
of chain)
Right Side of Chain
4. Hold file guide level. Make sure 30° mark on
file guide is parallel to center of guide bar (see
Figure 22). This will insure that you file cutters
at 30° angle.
5. File from inside towards outside of cutter until
sharp. Only file in this one direction (see Figure
22). Note: Two or three strokes with file should
sharpen cutter.
6. After each cutter is sharpened, move chain for-
ward to sharpen next cutter. File all cutters on
one side of chain.
7. Move to other side of chain and repeat process.
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced as cut-
ters are sharpened. After every second or third sharp-
ening, reset cutter depth gauges.
1. Place depth gauge tool (.025") firmly across top
of two cutters. Make sure depth gauge enters slot
in depth gauge tool (see Figure 24).
2. Use medium flat file. File depth gauge level with
depth gauge tool.
3. Remove depth gauge tool. With flat file, round
off front corner of cutter depth gauge (see Fig-
ure 25).
After several hand filings, have authorized service
center or sharpening service machine sharpen chain.
This will insure even filing.

REPLACING SAW CHAIN

Replace chain when cutters are too worn to sharpen or
when chain breaks. Only use replacement chain noted
in this manual. Always include new drive sprocket when
replacing chain. This will maintain proper driving of
chain. Note: For proper chain and drive sprocket, see
Replacement Parts and Accessories, page 17.
Depth Gauge Tool
Figure 24 - Depth Gauge Tool On Chain
Front Corner
Figure 25 - Round Off Front Corner Of Depth
Gauge
16
Flat File
Depth
Gauge
Depth Gauge Slot
.025"
.635 mm
113005