Cutting With The Chain Saw; Felling A Tree (Cutting Down A Tree) - Remington M12510US El Manual Del Propietario

OPERATING CHAIN SAW
Continued

CUTTING WITH THE CHAIN SAW

1. Connect saw to extension cord. Connect exten-
sion cord to power supply.
2. Make sure section of log to be cut is not laying
on ground. This will keep chain from touching
ground as it cuts through log. Touching ground
with moving chain will dull chain.
3. Use both hands to grip saw. Always use left hand
to grip front handle and right hand to grip rear
handle. Use firm grip. Thumbs and fingers must
wrap around saw handles (see Figure 12).
4. Make sure your footing is firm. Keep feet apart.
Divide your weight evenly on both feet.
5. When ready to make a cut, push the lockout but-
ton completely forward with the right thumb
and squeeze the trigger (see Figure 12). This
will turn saw on. Releasing trigger will turn saw
off. Make sure saw is running at full speed be-
fore starting a cut.
6. When starting a cut, place moving chain against
wood. Hold saw firmly in place to avoid possible
bouncing or skating (sideways movement) of saw.
7. Guide saw using light pressure. Do not force saw.
The motor will overload and can burn out. It will
do the job better and safer at the rate for which it
was intended.
8. Remove saw from a cut with saw running at full
speed. Stop saw by releasing trigger. Make sure
chain has stopped before setting saw down.
9. Practice until you can maintain a steady, even
cutting rate.
Trigger
Figure 12 - Lockout Button and Trigger Location
113005
Switch Lockout Button
FELLING A TREE (Cutting Down a
Tree)
WARNING:
• Avoid kickback. Kickback can result in
severe injury or death. See Kickback,
pages 4 and 5, to avoid risk of kickback.
• Do not fell a tree without ample skill or
expert help.
• Keep children, animals, and bystand-
ers away from area when felling a tree.
• If two or more persons perform buck-
ing and felling operations at the same
time, provide ample distance between
operations. Provide distance of at least
twice the height of tree being felled.
WARNING: When felling a tree, be
aware of your surroundings. Do not
endanger any person, strike utility lines,
or cause property damage. If tree strikes
utility lines, contact utility company at
once.
Felling is the process of cutting down a tree. Make
sure your footing is firm. Keep feet apart. Divide your
weight evenly on both feet. Follow directions below
to fell a tree.
Before Felling a Tree
1. Before felling, inspect tree. Make sure there are
no dead limbs or branches that may fall on you.
Study natural lean of tree, location of larger
branches, and wind direction. This will help you
judge which way tree will fall.
2. Clear work area around tree.
3. Plan and clear a retreat path before felling. Make
retreat path opposite to planned direction of fall
of tree and at 45° angle (see Figure 13).
Retreat Path
45°
Retreat Path
Figure 13 - Retreat Path From Tree
11
Direction of Fall
Tree
Continued
www.desatech.com