Battery Information - Taylor 8123 Manual De Instrucciones

BATTERY INFORMATION

This scale operates on 1 – 3 volt CR2032 lithium battery (installed). There is a strip under
the lithium battery cover to prevent battery drain in shipping. Please remove the strip before
continuing with these instructions. Also, some models have a static cling label on the lens to
prevent scratching. Please remove before use.
Replace the battery when the Low Battery icon "
readings grow dim or irregular. To replace the battery:
1. Use one 3 volt CR2032 lithium battery.
2. Remove screw (or screws) from the battery compartment cover on the bottom of the scale and
remove the cover. Take care when removing and replacing the battery door screw. Do not turn
the screw in the wrong direction or over tighten it as this may strip the screw threads in the
plastic battery door.
3. Remove the old battery from the compartment.
4. Place the new battery with the "+" sign up into the battery compartment.
5. Replace the battery compartment cover and screw(s).
NOTE: Please recycle or dispose of batteries per local regulations.
WARNING: Batteries may pose a choking hazard. As with all small items, do not let children handle
batteries. If swallowed, seek medical attention immediately.
PRECAUTION: Do not dispose of batteries in fire. Batteries may explode or leak. Remove the
battery if the scale will not be used for a long period of time.
LIFTING GUIDE
• Important - if you cannot comfortably lift your luggage do not attempt to weigh it.
• Stand with luggage.
• Hold scale handle with both hands.
• Keeping back straight, bend knees then lift.
• Look ahead, not at the display, while lifting. The scale will beep to alert you once the weight
reading has been taken.
• Avoid twisting the back or leaning sideways. Keep shoulders level and facing same direction as
hips. Keep your back straight at all times.
• Keep luggage close to the body but not touching.
• Luggage only needs to be just clear of floor to take
a weight reading.
• Lift smoothly.
• When measurement is complete, lower the luggage in
the reverse manner you lifted. (FIG. 1 shows the correct lifting method).
OPERATING YOUR SCALE
1. Attach the strap around the luggage handle with the buckle. Ensure the buckle is securely
engaged.
2. Hold scale handle with both hands. Allow the strap to dangle beneath scale to enable an
accurate zero reading.
3. Press the " q " button to switch the scale on. Wait until the display shows zero.
4. Gently lift scale until luggage is off the floor.
5. When a stable weight reading is achieved, the scale will beep and display the weight.
6. Lower the luggage to the floor.
2
" or "Lo" appears on the display, or the
FIG. 1