Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Quick start guide
CS6529/CS6529-14/CS6529-15/CS6529-16/
CS6529-17/CS6529-19/CS6529-2/CS6529-25/
CS6529-26/CS6529-3/CS6529-4B
Introduction
This quick start guide provides you with basic installation and
setup instructions. A limited set of features are described in
abbreviated form.
You may refer to the Abridged user's manual provided in the
product package for installation and operation instructions,
or see the online Complete user's manual at
www.vtechphones.com for complete installation and
operation instructions.
Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone wall jack
Electrical outlet
(not controlled
by a wall switch)
Telephone base
power adapter
Telephone base
Electrical outlet
(not controlled
by a wall switch)
Charger adapter
Charger
Use only the power adapters and batteries supplied with
this product.
If you subscribe to telephone service from a cable
company or a VoIP service provider, contact your cable/
VoIP service provider for more information.
Battery installation and charging
Install the battery as shown below. Once you have installed the
battery, you may be able to make and receive short calls. For
best performance, charge the handset battery continuously for at
least 11 hours.
1.
Plug the battery connector
securely into the socket.
3.
Slide the battery
compartment cover towards
the center of the handset
until it clicks into place.
A DSL filter
(not included) is
required if you have
DSL high-speed
Internet service.
The DSL filter must
be plugged into the
telephone wall jack.
Telephone line
cord
IMPORTANT:
Check for a dial tone by pressing
installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are
properly done.
It may be a wiring problem. If you have changed your
telephone service to digital service from a cable company or
a VoIP service provider, the telephone line may need to be
rewired to allow all existing telephone jacks to work. Contact
your cable/VoIP service provider for more information.
Enter the handset menu
1.
Press MENU.
2.
Press
or
3.
Press SELECT.
To return to the previous menu, press CANCEL.
To return to idle mode, press and hold CANCEL.
2.
Place the battery with the
label THIS SIDE UP facing
up and the wires inside the
battery compartment.
4.
Place the handset in the
telephone base or charger
to charge.
. If you hear a dial tone, the
until the screen displays the desired feature menu.
Set date and time
1.
Press MENU.
2.
Scroll to Set date/time, then press SELECT.
3.
Use the dialing keys (0-9) to enter the month, date and
year and then press SELECT.
4.
Use the dialing keys (0-9) to enter the hour and minute.
to select AM or PM.
Press
or
5.
Press SELECT.
Set number of rings
You can set the answering system to answer an incoming
call after two, three, four, five or six rings; or toll saver. With
toll saver selected, the answering system answers after
two rings when you have new messages, or after four rings
when you have no new messages.
1.
Press MENU.
2.
Scroll to Answering sys, then press SELECT.
3.
Scroll to Ans sys setup, then press SELECT.
4.
Scroll to # of rings, then press SELECT.
5.
Press
or
to choose 6, 5, 4, 3, 2 or Toll saver,
then press SELECT.
Record your own announcement
You can use the preset announcement to answer calls,
or replace it with your own recorded announcement. The
announcement can be up to 90 seconds in length.
1.
Press MENU.
2.
Scroll to Answering sys, then press SELECT twice.
3.
Press 7 to record.
4.
Speak towards the microphone after the handset
announces, "Record after the tone. Press 5 when you are
done."
Press 5 when finished.
5.
IMPORTANT!
Refer to the online Complete user's manual for a full set of
installation and operation instructions. For manual download or
customer service, visit our website at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com
or call 1 (800) 267-7377.
Copyright © 2013 for VTECH TELECOMMUNICATIONS LTD.
All rights reserved. Printed in China.
96-008563-090-100

Publicidad

loading

Resumen de contenidos para VTech CS6529

  • Página 1 Charger Press until the screen displays the desired feature menu. • Use only the power adapters and batteries supplied with Copyright © 2013 for VTECH TELECOMMUNICATIONS LTD. this product. Press SELECT. All rights reserved. Printed in China. • If you subscribe to telephone service from a cable To return to the previous menu, press CANCEL.
  • Página 2 Utilice sólo los adaptadores y las baterías que vienen Todos los derechos reservados © 2013 para con el producto. Oprima SELECT (seleccionar). VTECH TELECOMMUNICATIONS LTD. • Si se suscribe al servicio telefónico de una compañía de Impreso en China. Para volver al menú anterior, oprima CANCEL (finalizar).

Este manual también es adecuado para:

Cs6529-14Cs6529-15Cs6529-16Cs6529-17Cs6529-19Cs6529-2 ... Mostrar todo