Fitting The Elements Onto The Appliance; Plugging In The Power Cord And Switching On The Appliance; Storing And Transporting The Appliance - Rowenta Silence Force Extreme Multi-Cyclonic RO82 Serie Manual Del Usuario

EN
USE
1 • Fitting the elements onto the
appliance
Clip the end of the hose to the suction inlet located
at the front of the appliance (fig.1). To remove,
unclip the end using the clip and remove.
Attach the accessory holder to the notch in the
parking position located at the back of the
vaccuum cleaner (fig.2) and store the accessories
on top.
Note: The accessory support does not need to be
removed to open the vacuum cleaner lid.
• Fit the metal telescopic tube to the end of the
nozzle until you hear a click indicating that it is
locked (fig.3). To remove, press the tube lock
button and remove.
• Fit the multi-surface nozzle (23) to the end of the
metal telescopic tube until you hear a click
indicating that it is locked (fig.4). To remove, press
the nozzle lock button and remove.
• Adjust the metal telescopic tube to the desired
length using the telescopic system (TELESCOPIC
SYSTEM) (fig.5).
Fit the corresponding accessory to the end of the
metal telescopic tube or the nozzle:
- For rugs and carpets: use the multi-surface
nozzle in the retracted brush nozzle position or the
Maxi Turbo-brush* (fibers and animal hair).
- For parquet and smooth floors: use the multi-
surface nozzle in the brush release position or for
best results use the parquet nozzle*.
- For corners and hard to reach spots: use the
telescopic crevice nozzle*.
- For upholstery and delicate surfaces: use the
brush with the nozzle (EASY BRUSH) or the
upholstery nozzle*.
IMPORTANT: always
disconnect your vacuum cleaner before
changing the accessories.
ERGONOMIC RECOMMENDATIONS
The ERGO COMFORT SILENCE range has
been designed to facilitate and improve user
comfort when vacuuming.
To prevent bending over and to ensure
upright posture, make sure to:
1. Adjust the length of the ERGO COMFORT
SILENCE metal telescopic tube to your body
(fig.6).
2. Place your second hand on the front of the
ERGO COMFORT SILENCE nozzle handle
(fig.7).
* According to model: these systems are specific to certain
models or are accessories available as an option.
switch off and
2 • Plugging in the power cord and
switching on the appliance
Unwind the power cord completely, plug in your
vacuum cleaner and press the ON/OFF button
(fig. 8).
ATTENTION: do not operate your vacuum
cleaner without the filtration system fitted
(foam, microfilter and filter).
Set the suction power using the manual power
switch* on the power nozzle (fig.9a* or 9b*):
• Position (MIN) for vacuuming delicate
fabrics (curtains, textiles).
• Position (Medium) for daily vacuuming of all
types of surfaces with low levels of
soiling.
• Position (MAX) for vacuuming hard floors
(tiled floors, parquet, etc.) and rugs
and carpets in the case of high
levels of soiling.
3 • Storing and transporting the
appliance
After use, switch off your vacuum cleaner by
pressing the ON/OFF button and unplug it (fig. 10).
Wind the power cord by pressing the power cord
rewind button (fig. 11).
It is easy to carry your vacuum cleaner using the
handle (8).
Do not carry your appliance using the dust
compartment handle (fig.12).
When storing your vacuum cleaner, place the tube
in its storage compartment at the back of the
appliance (fig.13). You do not need to remove the
accessory holder (30) to store the accessory range
(Fig.14).
4