Fitting The Plinth - Electrolux REX FI 5004 NXA+ Manual De Instrucciones

20 www.electrolux.com
50 mm

7.7 Fitting the plinth

170-220 mm
820-870 mm
900 mm
30-100 mm
The top of the appliance must be kept
clear to allow better air circulation. If a
wall unit is fitted above the appliance,
there must be a gap of 50 mm between
50 mm
this unit and the wall and it must be at
least 50 mm below the ceiling.
140-190 mm
Alignment height of 820 mm
If using a 140 to 170 mm
plinth, make a cut out as
shown.
If using a plinth higher than 100
mm but less than 140 mm, cut
the height compensation strip
supplied with the appliance to
the required depth and fit it be-
tween the plinth and the venti-
lation grille, pressing it into po-
sition below this grille.