Safety And Compliance; Electromagnetic Fields (Emf); Fcc Information - Philips HF3650 Manual Del Usuario

Ocultar thumbs Ver también para HF3650:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Suddenly the device
makes a beeping
sound.

Safety and compliance

Electromagnetic fields (EMF)

FCC Information

Solution
The backup alarm went off. This can happen up to 12 hours after you
have removed the power (adapter) and a set alarm time is due. The
alarm sound stops automatically after approximately 1 minute. You
also can stop the alarm sound immediately if you power up the
device for a brief moment.
To prevent the back-up alarm to go off when the power is removed
(e.g. storage) just have the alarms disabled prior to powering down.
- This appliance meets the safety requirements in the USA and
Canada for portable electric luminaires: UL153, UL8750 and CSA
22.2 no. 250.4.
- This appliance meets the safety requirements in the USA and
Canada for Audio, Video and Similar Electronic Apparatus UL60065
and CSA 22.2 No. 60065-03
- This device complies with the EMC requirements of the USA and
Canada: FCC part 15, and ICES-003, ICES-005.
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
- This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the
receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
English
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hf3651

Tabla de contenido