Technical Data; Power Requirements - Truper DESI-36 Instructivo

Technical Data

Description
Bits Support
Rechargeable Battery
Charge Time
Charger
Output
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING

Power Requirements

Preferably, avoid using extension cables. In the event using one is absolutely necessary, make sure the
CAUTION
following requirements are followed:
WARNING When using an extension cable, verify the gauge is enough for the power that your product needs. A lower
gauge cable will cause voltage drop in the line, resulting in power loss and overheating.
The following table shows the right size to use depending on cable's length and the ampere capability shown in the tool's
nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
WARNING When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed for
operating outdoors and reduce the risk of electric shock.
Code
Speed
Voltage: 3,6 V
2 hours
Input
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge - Reference NMX - J - 195 - ANCE - 2006
DESI-36
17033
Wireless Screwdriver
220 RPM
1/4"
Capacity: 1,3 Ah
Voltage: 127 V~ 60 Hz
Voltage: 5 V
Power cord grips used in this product: Type "Y".
Charger Build Quality: Double Insulation
Authorized Service Center.
Extension Gauge
From 6 ft to 49 ft
18 AWG
16 AWG
14 AWG
8 AWG
grounded
Type: Ion-Lithium
IP Grade
IP20
200 mA
0,5 A
| Higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3