Safety Warnings For Power Screwdrivers - Truper DESI-36 Instructivo

Safety Warnings for
Power Screwdrivers
Charging the Screwdriver
• Misusing the charger may cause damages.
• Regularly check the charger is not damaged, especially
the connector cable and the housing.
• Do not use the charger if it was submitted to knocks or
discharge. Go to a
Center to repair before using it.
• For no reason at all disassemble the charger. Repairs
shall only be carried out by
Authorized Service Center staff. Improper assembly may
cause fire or electric shock.
• Never use the charger in places where explosive or
flammable materials are present.
• Connect the charger only to household power outlet. Do
not connect the charger if the power outlet has a different
voltage tension different to the one indicated in the
specifications label.
• A faulty electric installation or excessive tension in the
power outlet may originate an electric discharge.
• Connect the charger into a power outlet with easy access
to be able to disconnect quickly in case of fault.
• Not charging the screwdriver correctly may damage the
battery, the charger and the screwdriver.
• Charge the screwdriver in a 32 °F to 113 °F environment.
Ideal environment temperature is 73 °F
• Double check the ventilation is adequate when charging
the batteries. In this process gases are released.
• Charge the screwdriver inside. Do not charge outdoors.
• Check the charger is not in humid environment.
Otherwise there is risk of electric shock.
• Do not use the screwdriver for purposes different from its
designed. The charger is only built to charge the
screwdriver. Different uses may result in fire or
fatal electric shock.
• Do not try to charge the screwdriver with a charger that is
different from the one supplied.
• Use the charger only to charge the screwdriver and not as
power supply while operating the screwdriver.
• Do not set object onto the charger. Do not cover,
because it overheats. Never set it close to heat sources.
• Set the power cable in a way that nobody will trip with it
or step on it.
• After charging the screwdriver always disconnect the
charger from the power supply.
• Never pull or disconnect the charger using the
connection cable.
• Preferably, avoid using extension cables. If absolutely
necessary using an extension cable double check the
electric requirement mentioned in page 3 are observed.
• Never set the screwdriver or the accessories onto o near
hot surfaces.
Select the Adequate Bit
recommended by
• Keep the screwdriver bits in good repair. This measure
reduced the load onto the tool and extends the tool useful
Authorized Service life.
When Operating the Screwdriver
screws. IT IS NOT A DRILL.
• This is a light-work tool. It shall not be used to remove or
set screws requiring a high torque.
• Do not try to modify the tool or the accessories in no
way.
• Never use the screwdriver when the charger is
connected.
• Turn ON the screwdriver after setting the bits.
• Use extreme care when screwing screws with grove head.
The tool may slide away.
• Do not use too much force.
• Do not use this tool single-handedly.
• After each use remove the bit and the extensions. Store
them properly.
Children may swallow small parts and choke.
Keep children away from small parts.
Hold the power tool by the insulated gripping
parts when carrying out operations where the
fastener may get into contact with hidden cables
or its own power cable.
Fasteners making contact with a power cable may turn
"alive" the metal parts of the tool and as consequence,
cause an electric shock to the operator.
CAUTION
• Use only screwdriver bits
CAUTION
• This tool is designed to work with
WARNING Danger of asphyxiation!
.
ENGLISH 5