Ega Master 58775 Manual De Instrucciones página 41

Note:
1. When entering angle mode, the unit will be degree.
2. When angle is in auto initiate mode, please keep the wrench steady without any
disturbance.
3. After a short time, the angle function will enter initiate mode and a flashing
appear.
4. When releasing force the wrench in angle mode, the display will show the corresponding
torque with flashing.
5. When 80% of the target degree is reached, the green LED will begin to flash and the alarm
tone will beep intermittently.
6. When 99.5% of the target degree has been reached, the alarm will change to a steady tone
and the green LED will stop flashing and stay on. The red LED will also illuminate.
will
41