Operation - Hart HLCG03 Manual Del Operador

OPERATION

NOTE: The LED will turn off 10 minutes after charging
has been completed.
 To remove the battery pack from the charger, depress
latches and slide the battery pack out of the charger.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
LED FUNCTIONS FOR BATTERY CHARGING
See Figure 1, page 7.
MODE
Quick Red Blinks
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 6
LED
Plugged into AC power supply and ready to charge. No battery pack
Solid Red installed. If no batteries are inserted, the charger LED will turn off 5 min-
utes after being plugged into AC power supply.
Hot battery pack
When battery pack reaches cooled temperature, charger begins charge
mode.
Cold battery pack
Flashing Red
When battery pack reaches warmed temperature, charger begins charge
mode.
Deeply discharged
Charger conditions battery until normal voltage is reached, then begins
charge mode.
Battery pack or charger error.
• Try to repeat the conditions a second time by removing and reinstalling
the battery pack. If the LED Error status repeats a second time, try
Pattern of Two
charging a different battery.
• I f a different battery charges normally, dispose of the pack that received
the Error (see your battery pack manual for instructions).
• I f a different battery also indicates Error, the charger should be replaced.
Flashing Green Battery is being charged.
Battery charging is complete. LED will turn off 10 minutes after charging
Solid Green
has been completed.
This product has a Three-year Limited Warranty.
For Warranty details go to www.HARTtools.com
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
ILLUSTRATIONS START ON PAGE 7.
When a hot battery pack is placed on the charger, the charger
LED will turn red and begin flashing. When the battery
pack cools, the charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the charger LED will
turn red and begin flashing. When the battery pack warms
the charger will automatically begin charging.
ACTION
5 – English