Redline Sports G01320W Manual Del Usuario página 6

PARTS REQUIRED:
16 pcs - H7 Phillips Flat Head
Screw
4 pcs - P3 Leg
IMPORTANT NOTE:
1. Do not remove the protective plastic coating until legs are
fully installed onto table cabinet.
2. Open leg panels slowly and carefully.
3. Protective plastic coating must be removed at top of leg
before installing assembled leg onto table cabinet.
STEP 3:
Carefully apply A2 Glue inside the V-Groove of P3 Leg
as shown in FIGURE 3.
Carefully fold P3 Leg and attach P6 Leg Bottom Board
to the P3 Leg using pre-drilled pilot holes with H7 Screws
as shown in FIGURE 3.
Thread P7 Leg Leveler into P6 Leg Bottom Board as
shown in FIGURE 3.
Repeat the same procedure for the other P3 Legs.
16 pcs - H1 Allen Head Bolt
STEP 4:
Attach four P3 Leg assembly from STEP 3 to previous cabinet assembly from STEP 2 using H1 Allen Head Bolts
with H2 Flat Washers as shown in FIGURE 4. Using T1 Allen Wrench to tighten all H1 Bolts.
H2
H1
H2
H1
H1
H2
P2
All Rights Reserved.
© 2012 Escalade Sports
4 pcs - P6 Leg Bottom Board
4 pcs - P7 Leg Leveler
1 pc - A2 Glue
PARTS REQUIRED:
16 pcs - H2 Flat Washer
P3
P1
FIGURE 3
A2
IMPORTANT NOTE:
Please use old newspaper
or such as to not allow any
dripping glue to create any
cleanup issues.
When leg assemblies are
complete, properly dispose
of empty glue container.
1 pc - T1 Allen Wrench
THIS STEP REQUIRES TWO OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND
For Customer Service Call 1-888-996-2729
6
P7
H7
P6
P3
P3
Bolt holes this
position
SET IT ON ITS LEGS.