13 pcs - H8 Phillips Round Head Bolt
13 pcs - H9 Lock Nut
13 pcs - P12 Yellow Player
STEP 7:
Slide P13 3 Player Rods, P14 5 Player Rod and
P15 2 Player Rod through C1 Rod Bushings of
one P1 Side Apron as shown in FIGURE 7.
IMPORTANT NOTE: Please note the location
of the hole that is near one end of each rod.
This is the handle end of the rod.
Place one P17 Rod Bumper and one P16 Rod
Washer on each rod as shown in FIGURE 7.
Place P12 Yellow Players on each rod as
shown in FIGURE 7.
IMPORTANT NOTE: The goalie should be
at your left and your team (player face)
facing to the right.
Place one P16 Rod Washer and one P17 Rod
Bumper on each rod as shown in FIGURE 7.
= P11 Red Player
= P16 Rod Washer
= P17 Rod Bumper
STEP 8:
Align P12 Yellow Player to each player hole and attach
using H8 Bolts with H9 Lock Nut as shown in FIGURE 8
and DETAIL B.
Attach P18 Rod End Caps to the rod as shown in
FIGURE 8.
Slide P19 Rod Handle onto each rod end with the
small hole shown in FIGURE 8.
IMPORTANT NOTE:
A small amount of liquid soap applied inside each
P19 Rod Handle will allow them to slip onto rod easier.
DETAIL B
H8
P12
Rod
All Rights Reserved.
© 2012 Escalade Sports
PARTS REQUIRED:
2 pcs - P13 3 Player Rod
1 pc - P14 5 Player Rod
1 pc - P15 2 Player Rod
RIGHT
C1 Rod Bushing
Note: C1 Rod Bushings
are already attached
onto each P1 Side
Apron
FIGURE 8
Soccerman
facing up
H9
8 pcs - P16 Plastic Rod Washer
8 pcs - P17 Rod Bumper
4 pcs - P18 Rod End Cap
4 pcs - P19 Rod Handle
OVERHEAD VIEW
LOOKING DOWN ONTO TABLE
P13
P14
3 Player Rod
5 Player Rod
P19
Rod Handle
For Customer Service Call 1-888-996-2729
8
Hole / Handle End
P15
2 Player Rod
FIGURE 7
P18
Rod End Cap
LEFT
P13
3 Player Rod
P19
Rod Handle
Note:
Small Hole