Tabla de contenido
Publicidad
3.
Install the Trim
Valve Stem
Adapter
Adaptateur de
tige de valve
Adaptador de la
espiga de la válvula
Screw/Vis/Tornillo
Finished Wall
Mur fini
Pared acabada
Firmly press the valve stem adapter onto the valve stem.
Secure the valve stem adapter to the valve stem with the correct length screw, as
selected in the "Install the Valve Stem Adapter" section of this guide.
Thread the two threaded studs into the threaded holes of the valve.
Place the front plate assembly over the threaded studs.
Thread the nuts onto the studs to secure the front plate assembly to the wall. Do
not overtighten the nuts.
NOTE: If the front plate assembly does not lay flat on the wall surface, loosen the
nuts and adjust the threaded studs, then re-tighten the nuts. The maximum distance
between the threaded studs from the wall is 7/16" (1.1 cm).
Visually inspect the front seal plate assembly to ensure that the foam seal is
completely covering the wall opening. If not, stop the installation and repair the
wall opening.
Place the escutcheon against the wall. The drain holes in the escutcheon should be
positioned downward.
Thread the ring onto the front plate assembly.
While holding the handle assembly with the handle in the 6 o'clock position and
the setscrew oriented down, align the pins of the handle assembly (not shown)
with the holes in the face of the escutcheon.
Ensure the handle assembly is tight against the escutcheon then tighten the
setscrew to secure.
NOTE: If the handle does not engage the valve or the escutcheon does not tighten to
the wall, replace the valve stem adapter with an adapter of appropriate length.
Kohler Co.
Thermostatic Valve
Valve thermostatique
Válvula termostática
Stud/Montant/Varilla roscada
Front Plate Assembly
Ensemble de plaque avant
Montaje de la placa frontal
Nuts/Écrous/Tuercas
Escutcheon
Applique
Chapetón
Ring/Anneau/Anillo
Setscrew
Vis de retenue
Tornillo de fijación
7
Handle Assembly
Ensemble de poignée
Montaje de la manija
1138916-2-A
Publicidad
Tabla de contenido
