Grounding Instructions - Uline H-6984 Guia De Inicio Rapido

GROUNDING INSTRUCTIONS

WARNING!
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service person if you are in doubt
as to whether the outlet is properly grounded.
Do not modify the plug provided with the
appliance – if it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
This appliance must be grounded. If it should
malfunction or break down, grounding provides a path
of least resistance for electric current to reduce the
risk of electric shock. This appliance is equipped with
a cord having an equipment-grounding conductor
and grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
1. This appliance is for use on a nominal 120-volt
circuit, and has a grounded plug. (See Figure 1)
Figure 1
Grounding
Pin
Grounded Outlet Box
Axle x 1
1. Unpack fan from carton. Remove banding from unit.
Hardware is packed in carton.
2. Place one cotter pin in one end of the axle.
3. Slide one washer down the length of the axle to rest
on cotter pin.
4. Slide wheel onto axle next to washer.
5. Locate the wheel/axle bracket on the fan and slide
the end without the wheel into the bracket hole until
the axle comes out the other end.
6. Slide wheel, then washer onto this end.
7. Insert cotter pin into the remaining hole in the axle
to hold wheel in place. (See Figure 3)
PAGE 2 OF 12
Grounded
Outlet
PARTS
Wheel x 2
WHEEL ASSEMBLY
2. A temporary adaptor may be used to connect
this plug to a two-pole receptacle if a properly
grounded outlet is not available. The temporary
adaptor should be used only until a properly
grounded outlet can be installed by a qualified
electrician. The green-colored rigid ear, lug or the
like extending from the adaptor must be connected
to a permanent ground, such as a properly
grounded outlet box cover. Whenever the adaptor
is used, it must be held in place by a metal screw.
(See Figure 2)
Figure 2
Adapter
Tab for
Grounding
Screw
NOTE: In Canada, the use of a temporary
adaptor is not permitted by the Canadian
Electrical Code. Make sure that the appliance
is connected to an outlet having the same
configuration as the plug. No adaptor should
be used with this appliance.
Washer x 2
NOTE: Additional washers may be needed if
wheel fit is too loose.
Figure 3
Cotter
Pin
Wheel
Washer
Adapter
Metal Screw
Grounded Outlet Box
Cotterpin x 2
Added Washer if
Needed
0220 IH-6984