Uline H-6984 Guia De Inicio Rapido página 4

3. Loosen four motor nuts. (See Figure 9)
4. Loosen tension screw and two nuts. (See Figure 10)
Figure 9
5. Slide motor upward. (See Figure 11)
6. Remove old belt and replace with new belt.
(See Figure 12)
Figure 11
7. Slide motor back into correct position.
8. Set belt deflection to 5/16" with moderate pressure.
9. Tighten tension screw, the two nuts on the tension
screw and motor nuts.
10. Replace fan blade and tighten set screw.
11. Replace front guard.
OPERATING ISSUE
Fan will not start.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 4 OF 12
MAINTENANCE CONTINUED
Figure 10
Figure 12
TROUBLESHOOTING
CAUSES
Power cord not plugged into outlet.
No power at the outlet.
Defective switch or motor.
1-800-295-5510
uline.com
USER SERVICING INSTRUCTIONS
WARNING!
Be sure to disconnect power supply before
attempting to service or remove any
components.
Do not attempt to service your fan beyond that
described in the user manual.
LUBRICATION
No lubrication is necessary, as the motor is equipped
with lifetime lubricated bearings.
STORAGE
1. Before storing the unit, it should be cleaned. See
"Cleaning" on page 3.
2. Wrap the power cord around the handle on the top
of the unit to keep it untangled. The fan should be
stored indoors. (See Figure 13)
Figure 13
RECOMMENDATIONS
Plug cord into outlet.
Plug cord into another outlet.
Contact Uline Customer Service.
Wrap cord
around
handle
0220 IH-6984