Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
CLEANING THE CONDENSER COIL
•
For efficient operation,it is important that the condenser surface be kept free of dust,dirt,and lint.
•
We recommend cleaning the condenser coil and fins at least once per month.
•
Clean with a commercial condenser coil cleaner,available from any kitchen equipment retailer. Brush the
condenser fins from top to bottom,not side to side.
•
After cleaning,straighten any bent condenser fins with a fin comb.
CLEANING THE FAN BLADE AND MOTOR
•
If necessary,clean the fan blades and motor with a soft cloth,If it is necessary to wash the fan blades,cover
the fan motor to prevent moisture damage.
CLEANING THE INTERIOR OF UNIT
•
When cleaning the cabinet interior ,use a solvent of warm water and mild soap.
•
Do not use steel wool,caustic soap,abrasive cleaners,or bleach that may damage the stainless steel
surface.
•
Wash door gaskets on a regular basis,preferably weekly. Simply remove door gasket from the frame of the
door,soak in warm water and soap for thirty (30) minutes,dry with soft cloth,and replace.
•
Check door gaskets for proper seal after they are replaced.
•
Periodically remove the shelves and pilasters from the unit and clean them with mild soap and warm water.
To remove the pilasters,first remove the shelves and shelf brackets. Then,simply lift the pilaster up and out.
WARNING
Disconnect power cord before cleaning any parts of the unit.
Troubleshooting
Before requesting any service on your unit, please check the following points. Please note that this guide serve
only as a reference for solutions to common problems.
SYMPTOM
Compressor not running.
POSSIBLE CAUSE
•
Fuse blown or circuit breaker
tripped.
•
Power cord unplugged.
•
Thermostat set too high.
•
Cabinet in defrost cycle.
6
CORRECTIVE ACTION
•
Replace fuse or reset circuit
breaker.
•
Plug in power cord.
•
Set thermostat to lower
Temperature.
•
Wait for defrost cycle to finish.
Publicidad
Tabla de contenido
Solución de problemas
