Omcan RE-CN-0021 Manual Del Usuario página 7

Cabinet is noisy.
Condensing unit runs for long
periods of time.
Cabinet Temperature Is too warm.
1 YEAR PARTS AND LABOUR / 4 YEARS PARTS ONLY ON COMPRESSOR WARRANTY
Within the warranty period, contact Omcan Inc. at 1-800-465-0234 to schedule an Omcan authorized service
technician to repair the equipment locally.
Unauthorized maintenance will void the warranty. Warranty covers electrical and part failures not improper use.
• Loose part(s).
• Tubing vibration.
• Excessive amount of warm
product Placed in cabinet.
• Prolonged door opening or
door ajar.
• Door gasket(s) not sealing
properly.
• Dirty condenser coil.
• Evaporator coil iced over.
• Thermostat set too warm.
• Blocking air flow.
• Excessive amount of warm
product Placed in cabinet.
• Fuse blown or circuit breaker
tripped.
• Dirty condenser coil.
• Prolonged door opening or
door ajar.
• Evaporator coil iced over.
7
Troubleshooting
• Locate and tighten loose
part(s).
• Ensure tubing is free from
contact with other tubing or
components.
• Allow adequate time for
Product to cool down.
• Ensure doors are closed when
not in use. Avoid opening doors
for long periods of time.
• Ensure gaskets are snapped
in Completely. Remove gasket
and Wash with soap and water.
Check condition of gasket and
Replace if necessary.
• Clean the condenser coil.
• Unplug unit and allow coil to
defrost. Make sure thermostat
is not set too cold. Ensure that
door gasket(s) are sealing
properly.
• Set thermostat to lower
Temperature.
• Re-arrange product to allow
for Proper air flow. Make sure
there Is at least four inches of
clearance from evaporator.
• Allow adequate time for
product to cool down.
• Replace fuse or reset circuit
breaker.
• Clean the condenser coil.
• Ensure doors are closed when
not in use. Avoid opening doors
for long periods of time. (see
above)