Important Safety Instructions - Tripp-Lite LC1200 Manual De Operación

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during
the installation, operation and storage of all Tripp Lite line conditioners.
Failure to heed these warnings will void your warranty.
Line Conditioner Location Warnings
• Install your line conditioner indoors, away from excess moisture and heat, direct
sunlight, and dust and other conductive contaminants.
• For best performance, keep the indoor temperature between 32° F and 104° F
(between 0° C and 40° C).
• Leave adequate space around all sides of the line conditioner for proper ventilation.
Line Conditioner Connection Warnings
• Connect your line conditioner directly to a three-wire, grounded AC power outlet. Do
not remove or modify the ground pin of the line conditioner's plug. Do not use
adapters that would eliminate the line conditioner's connection to ground.
• Do not use extension cords between the line conditioner and the AC outlet. If
necessary, a Tripp Lite surge protector may be used between the line conditioner and
the AC outlet.
• If you are connecting your line conditioner to a motor-powered AC generator, the
generator must provide clean, filtered computer-grade output. Connecting your line
conditioner to a generator will void its Ultimate Lifetime Insurance.
Equipment Connection Warning
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended. Do not use this
equipment in the presence of a flammable anesthetic mixture with air, oxygen or
nitrous oxide.
Line Conditioner Maintenance Warning
• Tripp Lite line conditioners require no maintenance. Keep the line conditioner dry at all
times. DO NOT open the unit for any reason.
15-12-402-933510.indb 2
2
1/18/2016 12:45:53 PM