Ecco 7900 Serie Instrucciones De Instalacion Y Uso

ECCO'S 7900 Series - Pulse
dependable, cost effective LED warning solutions
offering a choice of two light intensity levels that meet
either SAE Class I (7960) or SAE Class II (7940)
requirements. Pulse
®
or quad fl ash operation and hi/lo intensity control, each
model offers a long maintenance free service life, ex-
tremely low amp draw and a robust, vibration resistant
design.
, ,SAE J845:
 
IP-26 / IP-56
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the
safety information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices
are essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fi re.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that
s/he can operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use,
the vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open
trunks or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffi c, responding at a high rate of speed, walking on or around traffi c lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws
and regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.
Specifi cations:
Size: 7960, 7940
7960-VM, 7940-VM
Weight: 7960
7940
7960-VM, 7940-VM
Input Voltage: 12 to 24 VDC systems
920-0076-00 Rev. G
Installation and Operation Instructions
LED Beacons provide
®
Beacons feature 12-24V double
7960 - Class I
7940 - Class II
Permanent Mount - IP-56
Pipe Mount - IP-26
Vacuum Mount - IP-26
6.5" dia. x 5.6" high
6.5" dia. x 6.4" high
approx. 3.3 lbs.
approx. 2.2 lbs.
approx. 4.4 lbs.
7900 Series LED Beacons
Input Current:
3.73 Amps Maximum
Maximum power consumption: 39 watts
Flash Rate:
Double fl ash mode:
80 cycles/minute
Output Power(total):
400 Candela Seconds Maximum
Temp. Range: -30ºC to +50ºC
Quad fl ash mode:
65 cycles/minute
Page 1 of 4