Manuales relacionados para Sanus BLF328
Resumen de contenidos para Sanus BLF328
- Página 1 GET IT RIGHT THE FIRST TIME BLF328 Follow this step-by-step instruction manual to INSTRUCTION MANUAL speed up your installation. Para Español ver página 30...
- Página 2 Our US-based install experts shows how easy this DIY HeightFinder™ shows you are standing by to help. project will be? where to drill. Call us at: 800-359-5520 Watch it now at: Check it out at: SANUS.com/2783 SANUS.com/1172 Or, chat at: SANUS.com/chatSP...
-
Página 3: Before You Begin
Before you begin Remove the stand Install any accessories Protect the face from your TV of your TV — if attached. you may have purchased — if they when laying it down for installation. require the TV to be removed from the wall for assembly. -
Página 4: Important Safety Instructions
● Manufacturer is not responsible for damage or injury caused by incorrect assembly or use. If your TV (including accessories) exceeds this weight, this mount is NOT compatible. TV Weight Limit Visit SANUS.com or call customer service to 105 lbs. (including accessories) find a compatible mount. -
Página 5: Tools Needed
Wall wood studs Solid concrete or CAUTION: concrete block Construction DO NOT install ONLY install on in drywall alone these acceptable wall types. Drywall alone will hold Unsure the weight of your TV. ACCEPTABLE ACCEPTABLE Call Customer Service 1-800-359-5520 Tools Needed 1/2 in. - Página 6 Attach TV Bracket to TV STEP 1 WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
- Página 7 1.1 Select TV Screw Diameter 1.2 Select TV Screw Length and Spacers Only one screw size fits your TV. NO SPACER SPACER NEEDED • Flat Back TV • Flat Back TV • Rounded or with Irregular Back TV Extra Space Needed [TV brackets lay flat on your TV] [for deep inset holes...
- Página 8 1.3 Attach TV Brackets to Your TV MEASURE ADJUST TO WIDTH inches 7 ⅞ 11 ¾ 15 ¾ 400 mm position illustrated 19 ¾ 23 ¾ inch dimensions are approximate Measure the WIDTH and HEIGHT of your TV's mounting hole pattern. Adjust mounting tabs on TV brackets to match the width...
- Página 9 ASSEMBLE FOR HEIGHT ASSEMBLE FOR HEIGHT For height 300 mm or less For height greater than 300 mm ≤ 300 mm > 300 mm For hole pattern height 300 mm and less, align horizontal TV For hole pattern height greater than 300 mm, align horizontal TV brackets with mounting tabs to the inside.
- Página 10 1. 3 (continued) CENTER LOOSELY ASSEMBLE NO SPACER SPACER NEEDED Adjust TV brackets to align with your TV hole pattern. Install using the TV bracket must be centered on your TV, but can be offset up or screw /washer /spacer combination you selected for your TV.
- Página 11 SECURE ASSEMBLY TIGHTEN ALL SCREWS Securely tighten the screws from STEP 4 and STEP 6. Secure the TV brackets using four interface screws , starting with the TOP two screws in the notches shown.
- Página 12 STEP 2 Attach Wall Plate to Wall WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
-
Página 13: Wood Stud Installation
STEP 2A Attach Wall Plate Wood Stud Installation CAUTION: Avoid potential Min. 1 ½ in. (3.8 cm) personal injury or property damage! ● Drywall covering the wall Min. 16 in. (40.6 cm) Min. 3 ½ in. (8.9 cm) must not exceed 5/8 in. (1.5 cm) ●... - Página 14 Be sure you drill into the CENTER of the stud. TIP: CAUTION: our HeightFinder at sanus.com [www.sanus.com/1172]. Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Position wall plate template at your desired height, with the slotted 3 ½...
- Página 15 OPEN COVERS SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate . Ensure the wall plate is securely fastened to the wall before continuing on to the next step. Install wall plate using four lag bolts and firmly tighten...
- Página 16 Min. 16 in. (40.6 cm) To calculate your precise wall plate location, check out TIP: TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Position wall plate template on the wall at your desired height. Level and mark the hole locations.
- Página 17 DRILL INSERT 3 ¾ in. (9.5 cm) 3/8 in. (10 mm) Be sure the anchors are seated flush CAUTION: CAUTION: CAUTION: CAUTION: Never drill into the mortar between blocks. Never drill into the mortar between blocks. with the concrete surface. Drill four pilot holes using a 3/8 in.
- Página 18 STEP 2B (continued) OPEN COVERS SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate . Ensure the wall plate is securely fastened to the wall before continuing on to the next step. Rotate the covers to expose the mounting holes.
- Página 19 STEP 3 Attach TV to Wall Plate WARNING: Before starting assembly, verify this part is undamaged. If damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! Parts and Hardware for STEP 3 CABLE COVERS CABLE COVERS (ATTACHED)
- Página 20 3.1 Attach Arm Assembly to Wall Plate HANG HEAVY! You may need assistance with this step. CAUTION: Avoid potential personal injury or property damage! For CONCRETE APPLICATIONS: The arm assembly MUST remain centered in wall plate Hang the top hook of arm assembly , onto wall plate ,Then NOTE: For WOOD STUD APPLICATIONS, the arm assembly...
- Página 21 SECURE CLOSE COVERS CAUTION: Avoid potential personal injury or property damage! Always make sure both locking screws are tightened, so the arm assembly is securely fastened to wall plate Secure arm assembly onto wall plate using two locking Close the wall plate covers screws in the bottom location shown.
- Página 22 3.2 Hang TV onto Arm Assembly ATTACH HANG YOUR TV HEAVY! You may need assistance with this step. Press the bottom of the TV into the arm assembly until you hear Hang the TV onto the arm assembly by hooking the top support the lock click, securing the TV in place.
- Página 23 SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! Always make sure your securement screw is tightened, so the TV is securely fastened to the arm assembly To lock the TV onto arm assembly , install the securement screw on the vertical TV bracket...
- Página 24 Manage Cables ROUTE CABLES ATTACH COVERS IMPORTANT: Pull arm to its full extension, to leave enough slack and prevent stretching the cables when the arms are moved. Remove the cable covers from the arm by sliding to loosen. Reattach cable covers to capture the cables.
-
Página 25: Level Adjustment
Adjustments LEVEL ADJUSTMENT TILT ADJUSTMENT NOTE: If you do not intend to adjust the tilt for different viewing locations, you can tighten the tilt tension knob , to prevent unwanted movement. If needed, use hex key to tighten more firmly. CAUTION: Screw MUST be loosened before STEP 2. - Página 26 EXTEND / RETRACT -- ONLY IF NECESSARY TV LATERAL SHIFT HEAVY ! You may need assistance with this step. CAUTION : Avoid potential injuries or property damage! Do NOT adjust the arm position from center for concrete applications. MUST remain centered in wall plate for all concrete applications! For wood stud applications ONLY:...
- Página 28 REMOVE THE TV REMOVE THE ARM ASSEMBLY HEAVY ! You may need assistance with this step. Disconnect all cables from the TV. Remove securement screw Pull down on the release cord to release the TV. Carefully lift the TV from arm assembly...
- Página 29 Troubleshooting If you are uncertain about your hardware selection, contact Customer Service at 1-800-359-5520 TV Supplied TV supplied spacers Spacers : Use your TV supplied spacer/adapter for flat back TVs : Use your TV supplied spacer/adapter and spacer for: (AND you want your TV closer to the wall).
-
Página 30: Peso Máximo
● El fabricante no se responsabiliza de ningún daño o lesión resultante del montaje incorrecto o el uso indebido Peso máximo Si su TV (incluidos los accesorios) pesa MÁS, esta montura NO es compatible. 47,6 kg (incluidos los accesorios) Visite sanus.com o llame al número 1-800-359-5520 para (105 lbs.) NO EXCEDAS encontrar una montura compatible. La construcción PRECAUCIÓN: Montantes de madera Hormigón macizo o... -
Página 31: Seleccione El Diámetro De Los Tornillos Para El Televisor
(1/2 pulg.) ¡ESTAMOS AQUÍ PARA AYUDARLE! ¿Desea ver un video para comprobar lo fácil que es hacerlo usted mismo? Visualícelo ahora en: SANUS.com/2524 Acierte a la primera. HeightFinder™ le indica el lugar donde debe taladrar. Descúbralo en: SANUS.com/1172 Nuestros expertos en instalación de EE. UU. están listos para ayudar. -
Página 32: Seleccione La Longitud De Los Tornillos Y Los Espaciadores De Su Tv
Español 1.2 Seleccione la longitud de los tornillos y los espaciadores de su TV PÁGINA 7 SIN ESPACIADOR • TV con parte posterior plana [los soportes del televisor se apoyan planos sobre su TV] Utilice tornillos de televisor cortos. No es necesario usar espaciadores. -
Página 33: Paso 2A Fijar La Placa Mural
COLOCAR LA PLANTILLA DE LA PLACA MURAL CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta Height Finder disponible en sanus.com [www.san.us/1172]. Coloque la plantilla de la placa mural a la altura que desee y ubique los orificios muescados sobre las líneas centrales del montante. Nivele y marque la ubicación de los orificios. -
Página 34: Taladrar Los Orificios
COLOCAR LA PLANTILLA DE LA PLACA MURAL CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta Height Finder disponible en sanus.com [www.san.us/1172]. Coloque la plantilla de la placa mural en la pared a la altura que desee. Nivele y marque la ubicación de los orificios. -
Página 35: Fije El Conjunto Del Brazo A La Placa Mural
Español PASO 3 Fijar el televisor en la placa mural PÁGINA 19 ADVERTENCIA: Antes de empezar el montaje, compruebe que esta parte no esté dañada. Si lo está, no la devuelva al distribuidor. Póngase en contacto con el servicio de atención al cliente. -
Página 36: Organizar Los Cables
Español Organizar los cables PÁGINA 24 PASE LOS CABLES IMPORTANTE: xtienda el brazo por completo antes de pasar los cables. Retire la cubierta de los cables . Pase los cables por el brazo VUELVA A COLOCAR LA CUBIERTA Vuelva a colocar la cubierta de los cables por sobre los cables. -
Página 37: Solución De Problemas
Español DESPLAZAMIENTO LATERAL DEL TELEVISOR PÁGINA 26 ¡ELEMENTO PESADO! Es posible que necesite ayuda en este paso. PRECAUCIÓN: Evite posibles lesiones personales o daños materiales. NO ajuste la posición del brazo desde el centro cuando esté colocado sobre hormigón. El brazo DEBE permanecer centrado en la placa mural cuando se coloque sobre hormigón. - Página 38 Dimensions TV INTERFACE 23.62in 600mm 7.87in 200mm 7.87in 15.75in 200mm 400mm WALL PLATE TOP VIEW - EXTENDED TOP VIEW - EXTENDED SIDE VIEW - EXTENDED 15 deg 33.68in WALL IS ON TOP DOWN 855.6mm 21.83in 554.6mm 2.36in 18.72in 14.55in 369.6mm 475.6mm 60mm 9.27in...
- Página 39 Register your new mount and tell us how you like it for a chance to win in our monthly sweepstakes. Entering is quick and easy. Visit SANUS.com/1234 and follow three simple steps for your chance to win. "Monthly Prize" sweepstakes rules and restrictions apply. Visit SANUS.com/1234 for details.
- Página 40 800-359-5520 • info@sanus.com • SANUS.com SANUS • 6436 City West Parkway • Eden Prairie, MN 55344 USA ©2019 Milestone AV Technologies. All rights reserved. SANUS is a division of Milestone. 6901-602345 00 All other brand names or marks are used for identification purposes and are trademarks of their respective owners.